Replacing Cooling System Components; Replacing A T640 Air Filter; Removing A Front T640 Air Filter - Juniper T640 Hardware Manual

CHAPTER 26

Replacing Cooling System Components

Replacing a T640 Air Filter

Removing a Front T640 Air Filter

Copyright © 2017, Juniper Networks, Inc.
Replacing a T640 Air Filter on page 281
Replacing the T640 Standard Lower Front Fan Tray on page 286
Replacing the T640 Standard Upper Front Fan Tray on page 288
Replacing the T640 Standard Rear Fan Tray on page 290
Upgrading to the T640 Quiet Fan Trays on page 292
Replacing the T640 Quiet Lower Front Fan Tray on page 299
Replacing the T640 Quiet Upper Front Fan Tray on page 302
Replacing the T640 Quiet Rear Fan Tray on page 304
Removing a Front T640 Air Filter on page 281
1.
Installing a Front T640 Air Filter on page 283
2.
Removing a Rear T640 Air Filter on page 283
3.
Installing a Rear T640 Air Filter on page 285
4.
The front air filter, located below the FPC card cage in the front of the chassis, and installs
horizontally. The front air filter weighs approximately 1 lb (0.5 kg).The air filters are
hot-insertable and hot-removable.
To remove the front air filter (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Unwrap any PIC cables from the spools on the cable management system, and remove
2.
the cables from the tray. Arrange the cables so that they do not block the front of the
cable management system and tray, and secure them with temporary fasteners so
that they are not supporting their own weight as they hang from the connector.
Figure 124 on page 282):
281