Installing A Side Air Filter On A T640 Ac Power Supply; Figure 207: Removing The Ac Power Supply Side Air Filter - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide

Installing a Side Air Filter on a T640 AC Power Supply

394
Switch off the customer site circuit breakers to the power supply. Make sure that the
4.
voltage across the AC power source cable leads is 0 V and that there is no chance
that the cables might become active during the replacement.
Disconnect the AC power cord from the AC power source.
5.
Reattach the ESD grounding strap to one of the ESD points on the chassis.
6.
Grasp the front filter cover on the power supply faceplate and pull it straight off the
7.
power supply.
Remove the front filter element.
8.
Loosen the screws (using a Phillips (+) screwdriver, number 2) on the bracket located
9.
on the side of the power supply.
Pull the side filter, located on the left side of the AC power supply, out of the power
10.
supply.

Figure 207: Removing the AC Power Supply Side Air Filter

Air filter bracket
To install the side AC power supply filter:
Verify that the customer site circuit breakers to the power supply is off, that that the
1.
voltage across the AC power source cord is 0 V, and that there is no chance that the
AC power cord might become active during the replacement.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Air filter
Copyright © 2017, Juniper Networks, Inc.