Replacing The T640 Console Or Auxiliary Cable - Juniper T640 Hardware Manual

Replacing the T640 Console or Auxiliary Cable

Copyright © 2010, Juniper Networks, Inc.
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate port on the CIP. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
an RJ-45 connector. One RJ-45/DB-9 cable is provided with the router. If you want to
connect a device to both ports, you must supply another cable.
To connect a management console or auxiliary device:
Plug one end of the replacement cable into the appropriate
1.
port. Figure 87 on page 184 shows the external device ports on the CIP. The ports labeled
connect to the Routing Engine in the upper Routing Engine slot (
HOST 0
the ports labeled
HOST 1
slot ( RE1 ).
Plug the the other end of the cable into the device's serial port.
2.
Chapter 17: Replacing T640 Router Hardware Components
AUXILIARY port on the CIP. Both ports accept a cable with
connect to the Routing Engine in the lower Routing Engine
CONSOLE or AUXILIARY
), and
RE0
183