Removing The T640 Quiet Lower Front Fan Tray - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide

Removing the T640 Quiet Lower Front Fan Tray

300
To remove the quiet lower front fan tray:
Attach an electrostatic discharge (ESD) grounding strap to your wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Unwrap any PIC cables from the spools on the cable management system and remove
2.
the cables from the tray. Arrange the cables so that they do not block the cable
management system and tray, and secure them with temporary fasteners so that
they are not supporting their own weight as they hang from the connector.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Simultaneously pull the two releases on the cable management system. Lift it up and
3.
outward to lock it in place to access the lower fan tray.
Rearrange the PIC cables in the cable management system. For more information
4.
about proper cable arrangement, see
page 454.
Loosen the captive screws on the corners of the fan tray faceplate.
5.
Grasp both sides of the fan tray, and pull the fan tray out of the chassis approximately
6.
1 to 3 inches.
WARNING: To avoid injury, keep tools and your fingers away from the fans
as you slide the fan tray out of the chassis. The fans might still be spinning.
Press the two latches located on each side of the fan tray up to release the fan tray
7.
from the chassis.
When the fans stop spinning, place one hand under the fan tray to support it and pull
8.
the fan tray completely out of the chassis.
"Maintaining T640 PICs and PIC Cables" on
Copyright © 2017, Juniper Networks, Inc.