Performing Initial Configuration; Ex4300 Default Configuration - Juniper EX4300 Hardware Manual

CHAPTER 14

Performing Initial Configuration

EX4300 Default Configuration

Copyright © 2017, Juniper Networks, Inc.
EX4300 Default Configuration on page 207
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 215
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 218
Configuring the LCD Panel on EX Series Switches (CLI Procedure) on page 223
Each EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when the switch is shipped. The default
configuration file sets values for system parameters such as
Ethernet switching on all interfaces, enables IGMP snooping, and enables the LLDP and
RSTP protocols.
The following default configuration file is for an EX4300-24T switch:
NOTE:
The factory default configuration file has more interfaces for models that
have more ports.
The statement does not appear for models without PoE+ ports.
poe
Interfaces ge-0/0/0 through ge-0/0/23 are network port interfaces.
Interfaces ge-0/2/0 through ge-0/2/3 and xe-0/2/0 through xe-0/2/3 are
SFP/SFP+ uplink module port interfaces.
When you commit changes to the configuration, a new configuration file is created, which
becomes the active configuration. You can always revert to the factory default
configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.
system {
auto-snapshot;
syslog {
user * {
any emergency;
}
file messages {
any notice;
and , configures
syslog commit
207