Toshiba e-STUDIO 2555C Service Manual page 1323

Sub
05/08 Mode Element
element
08 Setting Process Fuser Print speed
mode switchover control at
low temperature
08 Setting Process Fuser Print speed
mode switchover control at
low temperature
08 Setting Process Fuser
mode
08 Setting Counter Maintenan PM counter
Mode ce
Item Subitem Code
5476
5476
5477
M 5550
Sub- Default Acceptable
Details
code value value
1 Recycled paper 0 0-5
2 Thin paper 0 0-5
Fuser belt type setting 1 0-1
Setting value Refer to 8 digits
contents
86
RAM Contents
M Use this code to change the color print speed for
A4/LT/B5 size at low temperature, or when defective
fusing occurs. When the value is set to "0" or "1",
defective fusing may occur for thick paper.
0: Disabled 1: Intermittent mode (color) 2:
Intermittent/speed change mode (color) 3: Speed
change mode 1 (color) 4: Speed change mode 2 (color)
5: Speed change mode (black/color)
* This code is valid for 45/50ppm only.
M Use this code to change the color print speed for
A4/LT/B5 size at low temperature, or when defective
fusing occurs. When the value is set to "0" or "1",
defective fusing may occur for thick paper.
0: Disabled 1: Intermittent mode (color) 2:
Intermittent/speed change mode (color) 3: Speed
change mode 1 (color) 4: Speed change mode 2 (color)
5: Speed change mode (black/color)
* This code is valid for 45/50ppm only.
M 0: type1 1: type2
* Normally do not change this setting. When the fuser
belt without lot number is replaced with the one with a
lot number, change the value from "0" to "1". The lot
number is printed on the gear on the front side of the
fuser belt.
M Sets the threshold for displaying a message for PM
timing.
0: Not displayed
<Default>
30ppm: 60000
35ppm: 70000
45ppm: 75600
50ppm: 84000
25ppm: 50000
[Unit: page]
Proce Servic
dure e UI
4
4
1
1