Toshiba e-STUDIO 2555C Service Manual page 1307

Sub
05/08 Mode Element
element
08 Setting Printer Maintenan Display of details of
mode ce CE80
08 Setting Printer Maintenan Display of details of
mode ce CE80
08 Setting Printer Maintenan Display of details of
mode ce CE80
08 Setting Printer General
mode
08 Setting Printer Feeding Performance
mode system / improvement at retry
Paper by bypass feeding
transport
08 Setting Printer Feeding Performance
mode system / improvement at retry
Paper by bypass feeding
transport
Item Subitem Code
4706
4706
4706
4708
4713
4713
Sub- Default Acceptable
Details
code value value
1 M 0 0-15
2 C 0 0-15
3 K 0 0-15
Switchover setting of 0 0-1
transport control for
custom size
(297x431.8mm)
0 Plain paper/Recycled 0 0-1
paper
1 Thick paper 1 0 0-1
70
RAM Contents
M Displays the details of CE80. Enter "0" to clear the
error.
0=Normal, 1=Error
bit0: Not connected
bit1: Mix
bit2: Checksum mismatch
bit3: Gradation module error
M Displays the details of CE80. Enter "0" to clear the
error.
0=Normal, 1=Error
bit0: Not connected
bit1: Mix
bit2: Checksum mismatch
bit3: Gradation module error
M Displays the details of CE80. Enter "0" to clear the
error.
0=Normal, 1=Error
bit0: Not connected
bit1: Mix
bit2: Checksum mismatch
bit3: Gradation module error
M When feeding 305 x 457 mm sized paper by bypass
feeding, set the value of this code to "1" for JAM
detection. When the value is set to "1", the print speed
decreases.
0: Disabled (Setting for 297 × 431.8 mm)
1: Enabled (Setting for 305 × 457 mm)
M Use this code when retry by bypass feeding occurs
frequently and the performance decreases. Note that
the performance decreases if this setting is enabled
when retry does not occur.
0: Disabled 1: Enabled
M Use this code when retry by bypass feeding occurs
frequently and the performance decreases. Note that
the performance decreases if this setting is enabled
when retry does not occur.
0: Disabled 1: Enabled
Proce Servic
dure e UI
4
4
4
1
4
4