Selecting Cross-Point Assign Tables; Exporting Source Names And Destination Names; Making Settings For Audio Mixer - Sony MVS-8000X SystemMVS-7000X System User Manual

• Press directly on the list of copy sources (left-side
list) or the list of copy destinations (right-side list) in
the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1 Left No
2 Right No
3
Press [Copy].
A confirmation message appears, asking whether or
not to execute the copy.
4
To execute the copy, press [Yes], and to cancel the
operation, press [No].

Selecting Cross-Point Assign Tables

You can select the cross-point assign table to be used for
each of the following banks or buses.
• M/E-1 to M/E-5 banks and PGM/PST bank
• Buses assignable to AUX delegation buttons
Notes
It is not possible to assign cross-point tables 5 to 14 to a bus
of a switcher operated by an MKS-8080/8082 AUX Bus
Remote Panel.
1
In the Panel >Xpt Assign menu, using any of the
following methods, select the switcher bank or bus.
• Press directly on the list on the left of the status area.
• Press the arrow keys on the list on the left to scroll
the reverse video cursor.
• Turn the knobs.
Knob Parameter Adjustment
1 Bank/Bus
No
2 Num
2
Using any of the following methods, select the table.
• Press directly on the list on the right of the status
area.
• Press the arrow keys on the list on the right to scroll
the reverse video cursor.
• Turn the knob.
584
Cross-Point Settings (Xpt Assign Menu)
Setting values
1 to 15
Selection of copy
source
Selection of copy 1 to 14
destination
Setting values
Switcher bank or 1 to maximum
bus selection value
Number of 1 to maximum
selected value
switcher banks
or buses
Knob Parameter Adjustment
3 Table No Selection of table
to be assigned
3
Press [Table Assign Set].
This sets the table for the selected switcher bank or
bus.
Exporting Source Names and
Destination Names
To send the source names and destination names to the S-
Bus, use the following procedure.
1
In the Panel >Xpt Assign menu, press [Name Export].
The Name Export menu appears.
2
Turn the knob to set the station ID.
Knob Parameter Adjustment
1 Station ID Station ID setting
a) If set to 255, the information is sent to all stations (with display of
"All").
3
Press [Src Name Export].
This exports the source names to the station selected in
step 2.
4
Press [Dest Name Export].
This exports the destination names to the station
selected in step 2.
Notes
Since destination names cannot be selected freely,
fixed names are used.

Making Settings for Audio Mixer

Enabling the function to link the audio
mixer
Notes
For audio mixer operations in this system, it is necessary
to set Mixer ESAM-II for the DCU 9-pin serial port.
For details, see "Serial Port Settings (Serial Port Assign
Menu)" (page 645).
Values
1 to 15
Setting values
a)
1 to 255