Table of Contents
Advertisement
When key blink is selected
Knob Parameter Adjustment
1
Blink Rate
2
Duty
When edge blink is selected
Knob Parameter Adjustment
1
Blink Rate
2
Duty
Video Processing
You can adjust the luminance and hue of the selected key
fill signal.
For example, to apply video processing to the signal
selected on the M/E-1 bank key 1 fill bus, use the
following procedure.
1
In the M/E-1 >Key1 menu, select HF7 'Video
Process.'
The Video Process menu appears.
2
Press [Video Process], turning it on.
3
Adjust the following parameters.
Knob Parameter Adjustment
1
Video
Gain
2
Y Gain
3
C Gain
4
Hue Delay Hue delay
5
Black
Level
To return adjustment values to their defaults
Press [Unity].
142
Key Setting Operations with the Key Control Block
Setting values
Length of blink
1 to 100
cycle
Proportion of
0.00 to 100.00
cycle for which
key inserted
Setting values
Length of blink
1 to 100
cycle
Proportion of
0.00 to 100.00
cycle for which
original state
holds
Setting values
–200.00 to
Video gain
+200.00
–200.00 to
Luminance gain
+200.00
–200.00 to
Chrominance
gain
+200.00
–180.00 to
+180.00
–7.31 to
Luminance black
level
+109.59
Key Setting Operations
with the Key Control
Block
This section describes the basic procedures for key settings
using the key control block.
Key type selection buttons
M/E delegation buttons
Key delegation buttons
MORE button
Key fill/key source selection buttons
Notes
To select [M/E 4] or [M/E 5], [Key5] to [Key8], and
[DSK5] to [DSK8] in the key control block, a previous
assignment in the Setup menu is required (see page 397).
Selecting the Bank and Keyer
To make key settings, first select the bank (from M/E-1 to
M/E-3 and PGM/PST) and keyer, then assign them to the
key control block.
For example, to set key 1 on M/E-1 with the key control
block, use the following procedure.
1
Using the M/E delegation buttons in the key control
block, press the [M/E 1] button, setting it on.
2
Using the key delegation buttons in the key control
block, press the [KEY1] button, setting it on.
This assigns the key control block to M/E-1 key 1.
Displays
Knobs
Edge type selection buttons
Advertisement
Table of Contents
