Saving A Macro - Sony MVS-8000X SystemMVS-7000X System User Manual

5
Repeat steps 3 and 4 to register the required events in
the macro.
The numeric display shows the last registered event
position, and the total number of events.
6
Press the [STOR 1] button in the memory recall
section.
This saves the created macro in the register and ends
the macro editing mode; the [MCRO] button lights
amber.
Notes
• During macro editing, if you press any of the mode
selection buttons in the Flexi Pad control block other
than [MCRO] button (the [WIPE] button, [DME] button,
and so on), the executed operation is also registered as an
event. In this case, the [MCRO] button stays lit red.
• While carrying out macro editing in the Flexi Pad control
block, pressing a button to which a macro attachment is
set does not execute the macro.
• In the simple type Flexi Pad control block, it is not
possible to undo a macro save.
Specifying an edit point
1
In the Flexi Pad control block, press the [MCRO]
button, turning it on.
This assigns the Flexi Pad control block to macro
operation.
2
While holding down the [MCRO] button in the Flexi
Pad control block, press the button in the memory
recall section showing the desired register name.
3
Specify the edit point by the following operation.
• To move the edit point to the event immediately
following the current macro event (the macro event
specified as the current edit point), press the [NEXT]
button.
• To move the edit point to the event immediately
preceding the current macro event, press the [PREV]
button.
Inserting an event
To add an event to an already created macro, use the
following procedure.
1
Specify the edit point (see page 509).
2
Carry out the event to be added on the control panel.
For details of events that can be registered, see
"Events" (page 496).
3
In the memory recall section, press the [INS] button.
This adds the new event after the event specified in
step 1.
Modifying an event
1
Specify the edit point (see page 509).
2
Carry out the event you want to modify on the control
panel.
3
Press the [MOD] button.
This modifies the event at the specified edit point as
carried out in step 2.
Deleting an event
1
Specify the edit point (see page 509).
2
Press the [DEL] button.
This deletes the event specified in step 1.
Deleting all events within a macro register
1
Specify the edit point (see page 509).
2
Press the [ALL] button, lighting it green.
3
Press the [DEL] button.

Saving a Macro

In the memory recall section, press the [STOR x]
(x=register number) button to save the edited macro in a
register.
To return to the state before editing, without
saving the macro editing results
Press the [EXIT] button to recall the same register again.
This returns to the state before editing, without saving the
macro editing results.
Macro Operations in the Simple Type Flexi Pad Control Block
509