Table of Contents
Advertisement
For details of tally settings, see "Setting the On-Air Tally"
(page 602) or "Making New Tally Generation Settings"
(page 655).
Notes
If "Independent" is set in the Engineering Setup >Panel
>Operation >Button Tally menu, then tallies are not shown
on the multi viewer.
To specify whether to show or hide the sub-
screen names
1
In the Multi Viewer menu, use any of the following
methods to select the target sub-screens.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter
Adjustment
1
Window No Sub-screen
selection
2
Press [Name Enable] to select either of the following.
Enable: Show the subs-screen name.
Disable: Hide the sub-screen name.
To make the setting for all of 10 sub-screens in a single
operation, turn [All Name Enable] on or off.
3
To set the name display position, adjust the following
parameters.
Notes
If you change any of the following parameter values,
the name display position will change on all sub-
screens. You cannot adjust the name display position
for each sub-screen.
Knob Parameter
Adjustment
2
Name
Horizontal
Position H
position
3
Name
Vertical
Position V
position
To assign outputs to the sub-screens
1
In the Multi Viewer menu, press [Output Assign].
The Output Assign menu appears.
2
Use any of the following methods to select the target
sub-screens in the list on the left.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter
1
3
Use any of the following methods to select the target
outputs in the list on the left.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
• Turn the knob.
Knob Parameter
2
a) For Multi Viewer 2, 25 to 48.
Setting values
This selects the sub-screen output from among the
1 to 10
signals assigned to numbers 1 to 24 (Multi Viewer 1)
and 25 to 48 (Multi Viewer 2).
4
Press [Set].
Enabling AUX Mix Transitions
An AUX mix transition is enabled by assigning the
combination of AUX buses used in the AUX mix
transition to consecutive odd-numbered and even-
numbered output connectors.
For details of AUX mix transitions, see "AUX Mix
Transitions" in Chapter 3 (Volume 1).
Notes
When an AUX mix transition is enabled, the video process
Setting values
for the two AUX buses operates with the settings for the
0 to 100
1
In the Switcher >Output menu, press [Aux Mix].
0 to 100
The Aux Mix menu appears.
2
In the list on the left, select the target odd-numbered
and even-numbered output connectors (for example,
11 and 12).
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
• Turn the knob.
Adjustment
Window No Sub-screen
selection
cursor.
Adjustment
Output No
Output
selection
Notes
cursor.
Signal Output Settings (Output Menu)
Setting values
1 to 10
Setting values
a)
1 to 24
621
Advertisement
Table of Contents
