Table of Contents
Advertisement
Setting the Signal Format
(Format Menu)
To set the format, that is, the frame frequency and number
of scan lines handled by each device, use the System
>Format menu.
To display the Format menu
In the Engineering Setup menu, select VF1 'System' and
HF3 'Format.'
Notes
After changing any of the following settings, be sure to
press [Execute] (or [FC Format Execute] for changing the
format converter signal format) to save the new values. If
you want to cancel the settings and return to the original
state, press [Clear] without pressing [Execute] or [FC
Format Execute]. When you press [Execute], some data is
lost (such as frame memory images). If you press [FC
Format Execute], memory is not initialized, and this data
is not lost.
Restrictions on signal formats and reentry
Reentry restrictions for an M/E on which a selected signal
format can be used depend on whether or not the color
corrector is used.
For details, see "Preparations" in Chapter 9 (Volume 1).
Setting the Signal Format
Specify the signal format to be handled by the devices.
The combinations of signal formats that can be selected are
as follows.
System
Field frequency
HD system 50
59.94
50
59.94
23.976
24
25
29.97
50
59.94
SD system 59.94
50
When the MVS-8000X is used with the 1080P signal
format or the MVS-7000X is used with multiple signal
formats, you need to install software options (see page
556).
1
2
3
Allowing 59.94(2x) Format Signals
on an AUX Bus
Effective number of
scan lines
When the signal format of this system is 1080i/59.94, it is
1080i
possible to handle different (59.94(2x)) format signals on
the AUX bus only.
1080P
You can output from a connector to which any of the
following is assigned.
1080PsF
Carry out the setting in the Engineering Setup >System
>Format >AUX Signal Format menu.
1
720P
480i
2
576i
Notes
In the System >Format menu, select the device for
operations.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1
Device
Selection of
device for
operations
Press [Signal Format].
A pop-up window appears.
Press the button for the desired signal format.
Preset, Edit Preview, AUX 1 to 48
Press [Signal Format] in the Engineering Setup
>System >Format menu, and then select [1080i/
59.94].
Press [AUX Signal Format].
Setting the Signal Format (Format Menu)
Setting values
1 to maximum
value
549
Advertisement
Table of Contents
