Table of Contents
Advertisement
When border is selected
Parameter group [1/2]
Knob
Parameter Adjustment
1
W
Border width
Parameter group [2/2]
Knob
Parameter Adjustment
1
L
Luminance
2
S
Saturation
3
H
Hue
When soft border is selected
Parameter group [1/2]
Knob
Parameter Adjustment
1
W
Border width
2
I
Degree of
softening of
inside of border
3
O
Degree of
softening of
outside of
border
Parameter group [2/2]
Knob
Parameter Adjustment
1
L
Luminance
2
S
Saturation
3
H
Hue
When soft edge is selected
Knob
Parameter Adjustment
1
S
Degree of
softening of
edge
When edge matte is selected
Knob
Parameter Adjustment
1
L
Luminance
2
S
Saturation
3
H
Hue
Buttons for positioning the wipe pattern
POS (position): Adjusts the position of the wipe pattern.
CNTR (center): Returns the wipe pattern position to the
center.
When you press the [POS] button, the alphanumeric
display first shows the name of the parameter, "H" or "V,"
and then the value of the parameter.
When the [POS] button is lit green, you can adjust the
position of the wipe pattern with the control knobs.
Knob
1
Setting values
2
0 to 100
Buttons for setting the wipe direction
NORM (normal): Sets wipe to normal (forward)
Setting values
direction.
0 to 100
NORM/REV (normal/reverse): Sets the wipe direction
0 to 100
to alternate between normal and reverse for each
359 to 0
transition.
REV (reverse): Sets wipe to reverse direction to normal.
Buttons for setting the wipe pattern limit
Setting values
PTN LIMT (pattern limit): Enables the following
settings for the pattern limit using the control knobs.
0 to 100
LIMT SET (limit set): If you change the pattern size with
0 to 100
the fader lever then press this button, this sets the
current size as the pattern limit.
0 to100
Knob
1
a) At 0%, executing the transition has no effect at all.
b) At 100%, the transition can be executed with the same effect as with no
Setting values
pattern limit set, but when the transition completes, background buses A
and B are not interchanged.
0 to 100
0 to 100
Other buttons
359 to 0
EXIT: Exits the editing mode, and returns the memory
recall section to wipe snapshot mode.
KNOB 1/2: When the control knob adjustments are on two
pages, this switches between parameter group [1/2]
Setting values
and parameter group [2/2].
0 to 100
Wipe modify clear
When the [WIPE] button is held down, holding down the
region selection button for the selected region together
Setting values
returns all the wipe settings of the region to the initial
0 to 100
status settings.
0 to 100
For details of the initial status, see "Saving User-Defined
359 to 0
Settings" in Chapter 18 (Volume 2).
Wipe Pattern Operations in the Multifunction Flexi Pad Control Block
Parameter Adjustment
H
Horizontal
position
Vertical position –200 to +200
V
Parameter Adjustment
P
Pattern limit
range
Setting values
–200 to +200
Setting values
a)
b)
0
to +100
(%)
181
Advertisement
Table of Contents
