Table of Contents
Advertisement
MVE-9000 multi format DME processor
The MVE-9000 is a "Digital Multi Effects" with multi-
format support.
For the MVE-9000, an optional MKE-9021A Input/Output
Board is available as a dedicated interface for integrated
use with the switcher.
There are two types of interfaces available for connecting
DMEs to the switcher: the dedicated interface and the SDI
interface.
For details, see "Setting the Interface Between the DME
and the Switcher" in Chapter 20 (Volume 2).
Notes
When using the SDI interface, the following operations are
different from when using the dedicated interface.
• Setting the input signals from the switcher to the MVE-
9000 (AUX bus outputs), and signals returned to the
switcher (reentry inputs).
For details, see "Setting the AUX Bus Output and
Reentry Input" in Chapter 20 (Volume 2).
• Selecting the combiner channels not in the key control
block, but in the Global Effect menu (see page 350).
Three-Dimensional
Transformation
Operations
Use the device control block to carry out three-
dimensional DME transformations.
For details of three-dimensional DME coordinate space,
see "Three-Dimensional Transformations" (page 269).
Basic Operations
This section explains how to use the device control block
(trackball) to carry out three-dimensional transformations.
Function assignment buttons
Region selection buttons (DME1 to 8)
Operating buttons
Device control block (trackball)
Buttons used when the three-dimensional
transform operation mode is enabled
LOCAL: Enable operations in the DME local coordinate
space.
GLB (global): Enable operations in the DME global
coordinate space.
The [LOCAL] and [GLB] buttons can be selected at
the same time.
SRC (source): Enable operations in the DME source
coordinate space.
TRGT (target): Enable operations in the DME target
coordinate space.
The [SRC] and [TRGT] buttons cannot be selected at
the same time. When these buttons are held down,
trackball and Z-ring operation is switched to a finer
control (fine mode).
Three-Dimensional Transformation Operations
Trackball
Z-ring
283
Advertisement
Table of Contents
