Cross-Point Control Block In Key/Aux Bus Delegation Mode - Sony MVS-8000X SystemMVS-7000X System User Manual

Cross-Point Control Block in Key/AUX Bus Delegation Mode

You can assign key and AUX buses to the key 1 row
buttons in the cross-point control block for use as
delegation buttons so that signal selection can be made in
the key 2 row.
In this case, the buttons in the cross-point control block
operate as follows.
1 Key/AUX delegation button row
2 Cross-point button row
3 Source name/bus name
display (for key/AUX buses)
A/B bus control block
a Key/AUX delegation button row
These buttons select a key bus or AUX bus.
In setup you can assign the following buses.
KEY1 to KEY8, DSK1 to DSK8, UTILITY 1, UTILITY
2, EXT DME, DME UTIL 1, DME UTIL 2, EDIT PVW
AUX 1 to 48, FMS 1, FMS 2, DME 1 V/K to DME 8 V/K,
CCR 1, CCR2
b Cross-point button row
These buttons select a cross-point on the bus selected with
the key/AUX delegation buttons.
Notes
• When you press a button in the cross-point button row
while holding down the button to which any of KEY1 to
KEY8 and DSK1 to DSK8 buses is assigned in the Key/
AUX delegation button row, you can select the cross-
point of the key source bus.
• When you select a cross-point while holding down the
button to which any of DME 1 V/K to DME 4 V/K buses
is assigned in the Key/AUX delegation button row, you
can select the image on the reverse side of the currently
viewed DME image.
c Source name / bus name display (for key/AUX
buses)
When the [DSPLY] button is on, these show the names of
the signals corresponding to the current bus delegation.
36
Names and Functions of Parts of the Control Panel
For details of assignment, see "Assigning a Key or AUX
Bus to a Button in the Key 1 or Key 2 Row" in Chapter 19
(Volume 2).
4 AUX MIX button 5 DSPLY [display] button
The following displays may also appear, depending on the
state of other buttons.
Button name
[DSPLY] [DEST] [KEY]
Off Off -
On Off Off
On On -
On Off On
a) When you are holding down the button to which any of KE1 to KEY8 and
DSK1 to DSK8 buses is assigned in the key/AUX delegation button row,
the video signal name is displayed. To display the key signal names when
other bus is selected, keep the [KEY] button held down.
b) When you are holding down the button to which any of KEY1 to KEY8
and DSK1 to DSK8 buses is assigned in the key/AUX delegation button
row, the key signal names are displayed. To display the key signal names
when other bus is selected, keep the [KEY] button held down.
d AUX MIX button
When AUX bus is selected using buttons in the Key/AUX
delegation button row, press this button, turning it on, to
execute an AUX mix transition.
For details of AUX mix transition operation, see "AUX
Mix Transitions" (page 119).
6 DEST button
7 KEY button
Display
A/B bus signal names
Key/AUX bus video
signal name or key signal
a)
names
Key/AUX bus names
Key/AUX bus video
signal name or key signal
b)
names