Sony MVS-8000X SystemMVS-7000X System User Manual page 172

You can set pattern replication independently for the main
pattern and sub pattern.
1
In the M/E-1 >Wipe menu, select HF5 'Main Modify.'
The Main Modify menu appears.
2
Press [Multi], turning it on.
3
Set the following parameters.
Knob Parameter Adjustment
1 H Multi
2 V Multi
3 Shift
4
To make more adjustments, press [Multi Adjust].
The Multi Adjust menu appears.
5
Make the following settings, as required.
H Invert: When this is on, alternate tiles are inverted
left-to-right.
V Invert: When this is on, alternate tiles are inverted
top-to-bottom.
Non-Mask: When this is on, even if the positioner
function is used to move the pattern position, the
pattern is always present on the screen.
Position: By adjusting the following parameters,
move the pattern position within the divisions
determined in step 3.
Knob Parameter Adjustment
1 Position H
2 Position V
a) See page 169.
Making a wipe pattern like a Venetian blind
(Pairing)
This slits the pattern into multiple strips in the horizontal
or vertical direction, making it like a venetian blind.
172
Basic Procedure for Wipe Settings
Setting values
Number of 1 to 63
repetitions of
pattern
horizontally
Number of 1 to 63
repetitions of
pattern
vertically
–100.00 to
Replication
layout +100.00
Setting values
–200.00 to
Horizontal
a)
+200.00
position of
pattern
–200.00 to
Vertical position
a)
of pattern +200.00
Pairing Off
• The parameter Width determines the width of the slits.
• The parameter H Offset determines the spacing in the
horizontal direction.
If a negative value is set, the even-numbered pairs of
strip and slit move to the left, and the odd-numbered
pairs move to the right. The value –100.00 represents the
maximum movement.
If a positive value is set, the even-numbered pairs of strip
and slit move to the right, and the odd-numbered pairs
move to the left. The value +100.00 represents the
maximum movement.
• The parameter V Offset determines the spacing in the
vertical direction.
If a negative value is set, the even-numbered pairs of
strip and slit move upward, and the odd-numbered pairs
move downward. The value –100.00 represents the
maximum movement.
If a positive value is set, the even-numbered pairs of strip
and slit move downward, and the odd-numbered pairs
move upward. The value +100.00 represents the
maximum movement.
1
In the M/E-1 >Wipe menu, select HF5 'Main Modify.'
The Main Modify menu appears.
2
In the <Pairing> group, select the slit direction.
H: Create slits in the horizontal direction.
V: Create slits in the vertical direction.
3
Set the following parameters.
Knob Parameter Adjustment
1 Width Width of the
slits
2 H Offset Spacing in the
horizontal
direction
3 V Offset Spacing in the
vertical direction
Applying modulation to the wipe pattern
(Modulation)
The pattern signal can be modulated, creating waves in the
horizontal, vertical, or radial direction along the edges.
Pairing On
Setting values
1 to 128
(integer)
–100.00 to
+100.00
–100.00 to
+100.00