Sony MVS-8000X SystemMVS-7000X System User Manual page 190

2
Depending on whether the DME wipe pattern is in
one-channel mode or two-channel mode, proceed as
follows.
For a pattern in one-channel mode: press [1st Ch],
turning it on.
For a pattern in two-channel mode: from the <Ch
Select> group, select the corresponding channel.
You can select more than one channel at the same
time.
3
In the <Position> group, press [Position], turning it on.
4
Set the following parameters.
Knob Parameter Adjustment
1 H
2 V
Display indications when multiple channels are
selected at the same time
The indications on the knobs show the settings of the
lowest-numbered channel. When you turn the knobs to
adjust the settings, this changes the settings on the
other channels by the same amount.
To return the DME wipe pattern position to the
center of the screen
In the <Position> group, press [Center].
Displaying and moving the position of the
DME wipe pattern (position select)
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
In the <Position Select> group, the one of the [Top
Left], [Top Right], [Bottom Left], and [Bottom Right]
buttons that is on indicates the current display position
of the DME wipe pattern.
2
In the <Position> group, press [Position], turning it on.
3
Depending on whether the DME wipe pattern is in
one-channel mode or two-channel mode, proceed as
follows.
In one-channel mode: press [1st Ch], turning it on.
In two-channel mode: from the <Ch Select> group,
select the corresponding channel. You can select
more than one channel at the same time.
4
To move the position of the DME wipe pattern, press
the button where you want to move to, turning it on.
190
Basic Procedure for DME Wipe Settings
Setting values
–200.00 to
Horizontal
+200.00
position
–200.00 to
Vertical
+200.00
position
The DME wipe pattern displayed on the screen moves
to the position of the specified button.
Setting relative positions to move the DME
wipe pattern
In two-channel mode, use the following procedure.
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
2
In the <Ch Select> group, select the target channels.
3
Press [Position] in the <Position> group, turning it on.
4
Set the following parameters.
Knob Parameter Adjustment
4 Relative H Relative
movement in
the horizontal
direction
5 Relative V Relative
movement in
the vertical
direction
For details of the method of DME wipe pattern
selection, see "DME Wipe Pattern Selection" (page
187).
Setting the DME wipe pattern size (Size)
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
2
Depending on whether the selected pattern is in one-
channel mode or two-channel mode, proceed as
follows.
For a pattern in one-channel mode: press [1st Ch],
turning it on.
For a pattern in two-channel mode: from the <Ch
Select> group, select the corresponding channel.
You can select more than one channel at the same
time.
3
Press [Size], turning it on.
4
Set the following parameters.
Knob Parameter Adjustment
1 Size Set size of
effect
a) The effect size when [Size] is off is taken as 100.00%.
Setting values
–400.00 to
+400.00
–400.00 to
+400.00
Setting values
a)
0.00 to 200.00