Masks; Applying A Dme Effect To A Key - Sony MVS-8000X SystemMVS-7000X System User Manual

Knob Parameter Adjustment
1 Soft Edge softness
• For a normal edge, when [SOFT EDGE] is enabled,
"Key Drop" mode turns on.
• When a luminance key or linear key is selected as the
key type, and clean mode is enabled, enabling [SOFT
EDGE] ends the clean mode.
Applying the zabton effects
When the [ZABTN] button is lit green, adjust the
following parameters.
Knob Parameter Adjustment
1 Size Pattern size
2 Soft Pattern edge
softness
Press the [MORE] button lit amber, changing it to green,
then adjust the following parameters.
Knob Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
4 Density Density

Masks

Using the main mask
In the key control block, press the [MAIN MASK] button,
turning it on.
The parameter settings depend on the mask source selected
as [Box] or [Pattern] in the <Mask Source> group of the
Main Mask menu for the key.
When box is selected
Knob Parameter Adjustment
1 Top Top position
2 Left Left position
3 Right Right position
4 Bottom Bottom position
When box is selected and the [MORE] button is lit amber,
there are more settings. Press the [MORE] button, so that
it changes from amber to green to make the extra setting.
Knob Parameter Adjustment
1 Soft Box softness
146
Key Adjustments (Key Control Block)
When pattern is selected
Setting values
Knob
0 to 100
1
2
3
a) The pattern is the same as a standard wipe. See "Wipe Pattern List" (page
357).
Using the subsidiary mask
In the key control block, press the [SUB MASK] button,
turning it on. The parameter settings depend on the mask
source selected as [Wipe] or [Utility 1 Bus] in the <Mask
Setting values
Source> group of the Sub Mask menu for the key.
0 to 100
When wipe is selected
0 to 100
Knob
1
2
Setting values
When utility 1 bus is selected
0 to 100
Knob
0 to 100
359 to 0 1
0 to 100
2

Applying a DME Effect to a Key

Notes
• When the SDI interface is used to connect the DME,
DME effects (including DME wipes) can be used in only
one place for one M/E bank.
• When the dedicated interface is used to connect the
DME, the number of keys to which DME effects
(including DME wipes) can be applied simultaneously
Setting values
for one M/E bank varies as follows depending on the
–100 (shown as
execution mode of the DME wipe pattern selected for the
–00) to +100
background.
–100 (shown as
–00) to +100
–100 (shown as
–00) to +100
–100 (shown as
–00) to +100
Setting values
0 to 100
Parameter Adjustment
Size Pattern size
Soft Edge softness
Pattern Pattern number
Parameter Adjustment
Size Pattern size
Soft Edge softness
Parameter Adjustment
Clip Reference level for
creating mask
signal
Gain Gain
Setting values
0 to 100
0 to 100
a)
1 to 24
Setting values
0 to 100
0 to 100
Setting values
+109 to –7
–100 (shown as
–00) to +100