Copy And Swap; Video Process; Color Corrector; Side Flags - Sony MVS-8000X SystemMVS-7000X System User Manual

Multi format switcher system with ccp-8000 series center control panel
Table of Contents

Advertisement

Copy and Swap

This function can be used to copy and swap the settings
among the M/E-1 to M/E-3, and PGM/PST banks or
between keyers.
The following settings can be copied or swapped.
• Overall settings for the M/E and PGM/PST banks
• Keyer settings
• Wipe settings in a transition control block
• Wipe settings in an independent key transition control
block
• DME wipe settings in a transition control block
• DME wipe settings in an independent key transition
control block
• Matte color settings (color 1, color 2, and how to
compose them)
• Color settings
• DME channel settings
• Format converter input settings (copy only)
• Format converter output settings (copy only)
For details, see "Copy and Swap" (page 230).

Video Process

The term "video process" is applied to adjustments to the
gain, hue, black level of the input video signal. There are
two types of adjustment; adjustment of an individual input
signal and adjustment as image effects on a particular bus.
For details, see "Video Process" (page 238).

Color Corrector

The color corrector enables video signal color correction
(black balance/white balance adjustment, gamma
correction, knee correction, etc.).
The color corrector includes the following adjustments.
• Input video processing
• Primary color correction
• Secondary color correction
• Luminance processing
• Spot color adjustment
• Output video processing
• YUV/RGB clip
For details, see "Color Corrector" (page 240).

Side Flags

The term "side flags" refers to the areas to left and right of
an image with aspect ratio 4:3 embedded within a 16:9
frame, when these areas are filled with a separate image
selected from the utility 1 bus.
Image to fill the side flag
areas (selected from
utility 1 bus)
Turn the side flag
function on
Side flag area
For details, see "Side Flags" (page 250).

Multi Program 2

By operating the switcher in Multi Program 2 mode, a
single switcher mix/effects bank can be used to create two
separate video outputs, referred to as "main" and "sub."
You can set backgrounds, keys, and transitions for each of
main and sub. For example, during broadcast of sports
events, two versions of the scene can be provided as shown
below, and switched simultaneously.
Input source with aspect
ratio
Side flag area
Basic Video Processing
25

Advertisement

Table of Contents
loading

Table of Contents