Table of Contents
Advertisement
Selecting Keys 5 to 8 for Next
Transition
Buttons to which keys can be assigned
To select keys 5 to 8 for the next transition, in addition to
assigning [KEY5] to [KEY8] for the operation, it is also
possible to make the selection with [KEY1/5], [KEY2/6],
[KEY3/7], [KEY4/8], [SHIFT], and [ADD].
The following describes this method of operation.
First in the Setup menu, assign the following to any
buttons:
[KEY1/5], [KEY2/6], [KEY3/7], [KEY4/8], [SHIFT],
and [ADD]
By way of example, this is the procedure for [KEY1/5].
To select key 5
Press [SHIFT], turning it on, then press the [KEY1/5]
button.
To select keys 1 and 5 simultaneously
1
Press the [KEY1/5] button alone.
This selects key 1.
2
Press [SHIFT], turning it on.
3
Holding down [ADD], press the [KEY1/5] button.
This selects keys 1 and 5 simultaneously.
Selecting Input Signals for Keys 5 to
8 in the Cross-Point Control Block
Buttons used for selection of keys 5 to 8
For the positions of the following buttons in the cross-
point control block, see page 33.
398
Using Keys 5 to 8
Key row Dedicated [SHIFT]
Key
a)
button
5
Key 1
Lit
row
6
Key 2
row
7
Key 1
row
8
Key 2
row
a) Button previously assigned in the Setup menu to selection of keys 5 to 8
To select the key 5 fill signal
1
Turn on the dedicated [SHIFT] button.
2
Turn off the [KEY3] button.
3
Select the signal in the key 1 row.
When a key delegation function is
assigned to the key 1 row
1
In the key 1 row, press the button assigned to the
desired key 5.
2
In the key 2 row, select the signal.
For details, see "Cross-Point Control Block in Key/AUX
Bus Delegation Mode" (page 36).
[KEY3]/[KEY4]
button
[KEY3] button off
[KEY4] button off
[KEY3] button lit
[KEY4] button lit
Advertisement
Table of Contents
