Table of Contents
Advertisement
The menu screen switches to the menu that was on the
screen immediately before the offline editing.
To append an event
This adds an event at the end of the macro.
1
Press [Append].
A blank row is added at the end of the macro listing.
2
Carry out steps 3 to 8 of the previous item, "To insert
an event," to edit an event.
To delete an event
1
In the macro listing, select the event you want to
delete.
2
Press [Delete].
This deletes the selected event.
If a deleted Event statement is followed by a Continue
statement, the Continue statement is converted to an
Event statement.
To close the Off Line Edit menu without saving the
editing results
Press [Exit] to return to the File Edit menu.
3
Press [Store].
This saves the results of the macro register or macro
file editing, and returns to the File Edit menu.
To create a new macro
1
From the list in any of the following menus, select an
empty register or file, and press [Off Line Edit] in the
button area.
• Macro >Register >Lock menu
• Macro >Register >Delete menu
• Macro >Register >Rename menu
• File >Shotbox, Macro >Macro >File Edit menu
The Off Line Edit menu appears.
2
Carry out steps 3 to 8 of the procedure "To insert an
event" (page 515), to create an the event.
516
Macro Attachment Assigning
Macro Attachment
Assigning
Macro attachment is a function whereby a macro register
is assigned to a control panel button or a particular position
of a fader lever, linking the execution of the button
function or a fader lever operation with a macro execution.
Setting a macro attachment to a button
Select one of the following three linking modes to make
the macro attachment.
Pre-macro: Mode in which the button function is
executed after macro execution has completed
Post-macro: Mode in which the macro is executed after
carrying out the button function
Macro only: Mode in which the button function is not
executed, and the macro only is executed
The selection of pre- or post-macro mode is carried out in
the cross-point control block of the PGM/PST bank or the
M/E banks. For the macro-only mode, assign the selection
function to a utility/shotbox control block button or user
preference button, and make the selection by pressing the
button. Alternatively, without pressing the button, you can
make the selection simply, by simultaneously pressing the
pre-macro and post-macro selection buttons in the cross-
point control block.
You can assign any one of the 250 macro registers to a
button.
For a button whose function is switched by delegation, you
can make a separate macro attachment for each function.
For each control panel, you can make up to 1000 macro
attachment settings.
The macro attachment setting is possible for the following
bus buttons.
Advertisement
Table of Contents
