Table of Contents
Advertisement
Making the primary setting automatic
In the <USB Storage Device> group, press [Auto Detect].
Reloading a USB Driver
To reload a USB driver, in the System >Maintenance
menu, press [Reload USB Driver].
Notes
If even after this operation the memory card is not
recognized, remove the memory card and reinsert it, then
try again.
Initializing the Hard Disk
If a file system corruption error has occurred on the hard
disk, you should initialize the hard disk.
1
In the <HDD> group of the System >Maintenance
menu, press [HDD Format].
An initialization confirmation message appears.
Notes
When the hard disk is operating normally, pressing
[HDD Format] has no effect.
2
To execute the initialization operation, press [Yes]. To
cancel, press [No].
If you have pressed [Yes], the hard disk initialization
operation is executed, and a finished message appears.
If you have pressed [No], the initialization operation is
canceled, and the System >Maintenance menu appears
again.
3
Press [OK].
Locking the Setup Menu Settings
To protect the data, you can inhibit operations in selected
setup menus. Use the following procedure. Note that it is
not possible to lock the Setup Operation Lock menu.
1
In the System >Maintenance menu, press [Setup
Operation Lock].
The Setup Operation Lock menu appears.
2
In the <VF Group> group, select the group including
the desired menu.
The status area shows a list of menu numbers and
menu names in the selected group.
Subsequent lock operations apply within the group
selected here.
3
Using any of the following methods, select the menu
or the set of menus as candidates for the locking
operation.
• Press directly on the list in the status area.
• Use the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter Adjustment
1
No
Selection of a
menu by its
number in the list
3
Num
Selection of
number of menus
in the list
• To select all setup menus within the selected group,
press [ALL].
You can also select a menu while it is open (see page
564).
4
Press [Lock Item Select].
This makes the selected menus candidates for locking,
and a padlock icon appears in the "Lock" box in the
unlocked state
.
Notes
If there are already one or more locked menus,
selection of lock candidates is not possible.
To deselect a lock candidate
After selecting a menu, press [Lock Item Select] once
more, to clear the Lock box.
To deselect all lock candidates in the selected VF
group
Press [Lock Item All Clear].
5
Repeat steps 2 to 4, to select all of the lock candidates.
6
Press [Lock].
A keyboard window appears.
7
Enter the password with a maximum of 16 characters,
and press [Enter].
If the password is correct, the menus selected in the list
of candidates are all locked. The padlock icon changes
to the locked state
.
Releasing the lock
When a lock is already applied, use the following
procedure.
System Maintenance (Maintenance Menu)
Setting values
1 to maximum
value
1 to maximum
value
563
Advertisement
Table of Contents
