Selecting Cross-Point Assign Tables - Sony MVS-8000X System User Manual

2
Using any of the following methods, select the number of the table to use
as the copy source and the number of the table you want to be the copy
destination.
• Press directly on the list of copy sources (left-side list) or the list of copy
destinations (right-side list) in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
2
3
Press [Copy].
A confirmation message appears, asking whether or not to execute the
copy.
4
To execute the copy, press [Yes], and to cancel the operation, press [No].

Selecting Cross-Point Assign Tables

For the M/E-1 bank or PGM/PST bank, you can select the cross-point assign
table to be used.
When the AUX delegation buttons of the AUX control block in the control
panel are selected, the table set for the M/E or P/P bank is used as the cross-
point assign table in the cross-point control block.
Notes
When manipulating the switcher buses with the MKS-8080/8082 AUX bus
remote panel, you can assign a different cross-point table for each bus.
However, it is not possible to assign cross-point tables 5 to 14.
1
In the Panel >Xpt Assign menu, use any of the following methods to select
the switcher bank.
• Press directly on the list on the left of the status area.
• Press the arrow keys on the list on the left to scroll the reverse video
cursor.
• Turn the knobs.
Knob
1
Parameter Adjustment
Left No Selection of copy source
Right No Selection of copy destination
Parameter
Bank/Bus No
Setting values
1 to 15
1 to 14
Adjustment Setting values
Switcher bank 1 and upwards
selection
Cross-Point Settings (Xpt Assign Menu)
973