Sony MVS-8000X SystemMVS-7000X System User Manual page 592

a)
Command name
Macro AT with A/B Bus
Macro TL with Region
DME Override
DME Graphic
System Manager Enbl
Plug-In Editor Enbl
Inhibit Set
Inhibit All Clear
K-SS Store
1st DSK Fader Inhibit
2nd DSK Fader Inhibit
3rd DSK Fader Inhibit
4th DSK Fader Inhibit
SWR1 LAN Status
SWR2 LAN Status
a) For the safe title on/off commands (from ME1 PGM1 ST-ME1 PGM4 ST
to AUX1 ST-AUX48 ST), the name of the assigned output signal is
shown.
b) Pressing this button to turn it on enables key snapshot operations for all
control blocks.
c) Control LAN status only.
Assigning a menu shortcut to a user
preference button
1
Referring to the procedure up to step 2 of "Assigning
Functions to User Preference Buttons" (page 589),
select [Menu Shortcut].
The user preference buttons [PREFS 1] to [PREFS 16]
flash amber.
2
Using any of the following methods, display the menu
to which you want to make a shortcut.
• In the menu control block, press the relevant top
menu selection button, then select VF and HF.
592
Setting Button Assignments (Prefs/Utility Menu)
Function
When registering an auto transition macro
event for the transition control block, on/off
setting of mode to save A/B Bus cross-point
settings
When registering a timeline macro event, on/
off setting of mode to save applicable region
DME override on/off
DME graphics on/off (applies to graphics for
channel selected in device control block)
Enable/disable operation from System
Manager
Enable/disable operation from an editing
keyboard
Inhibit cross-point button
Clear all cross-point button inhibit settings
Enable/disable key snapshot saving
Inhibit operation of the first downstream key
control block
Inhibit operation of the second downstream
key control block
Inhibit operation of the third downstream key
control block
Inhibit operation of the fourth downstream key
control block
SWR1 communications status
SWR2 communications status
Button status
Lit amber
On
On
On
On
Enabled
Enabled
Can be set only while
pressed (lit)
Can be set only while
pressed (lit)
b)
Enabled
On
On
On
On
c)
Communications
disconnected
c)
Communications
disconnected
• Press the menu page number button in the upper left
corner of the menu screen, then enter a menu number
from the numeric keypad window.
• Press a particular control panel button twice in rapid
succession.
3
Press the user preference button to which you want to
assign the shortcut.
The menu screen goes back to the Panel >Prefs/Utility
menu, and the selection is reflected in the status area.
The user preference buttons [PREFS 1] to [PREFS 16]
flash amber.
4
Repeat steps 2 and 3 as required, to assign all desired
menu shortcuts to the user preference buttons.
To abandon the process of menu shortcut
assignment
In the Prefs/Utility menu, press [Menu Shortcut] once
more.
This exits the menu shortcut assignment mode.
Off
Off
Off
Off
Off
Disabled
Disabled
When the function is
assigned
When the function is
assigned
Disabled
Off
Off
Off
Off
During
communication
During
communication