Blur Settings - Sony MVS-8000X SystemMVS-7000X System User Manual

When Video/Key is selected (with SDI-interfaced
DME)
Parameter group [1/2]
Knob Parameter Adjustment
1 V/K H
2 V/K V
3 V/K All
4 Video All
5 Key All
Parameter group [2/2]
Knob Parameter Adjustment
1 Video H
2 Video V
3 Key H
4 Key V
When Video is selected
.
Knob Parameter Adjustment
1 H
2 V
3 All
304
Applying Special Effects (Effects on the Overall Video Signal)
Setting values
Horizontal Video H value
defocusing of
shown
video and
key signals
Vertical Video V value
defocusing of
shown
video and
key signals
Horizontal Video H value
and vertical shown
defocusing of
video and
key signals
Horizontal Video H value
and vertical shown
defocusing of
video signal
Horizontal Key H value shown
and vertical
defocusing of
key signal
Settings values
Horizontal 0.00 to 100.00
defocusing of
video signal
Vertical 0.00 to 100.00
defocusing of
video signal
Horizontal 0.00 to 100.00
defocusing of
key signal
Vertical 0.00 to 100.00
defocusing of
key signal
Setting values
Horizontal 0.00 to 100.00
defocusing of
video signal
Vertical 0.00 to 100.00
defocusing of
video signal
Horizontal H value shown
and vertical
defocusing of
video signal
When Key is selected (with SDI-interfaced DME)
Knob Parameter Adjustment
1 H Horizontal
defocusing of
key signal
2 V Vertical
defocusing of
key signal
3 All Horizontal
and vertical
defocusing of
key signal
5
To cancel black level leaking that can occur at the edge
of the screen when the Defocus effect is enabled, press
[Clean Defocus], turning it on.
Masking the Defocus effect with a selected
pattern
Press [Mask] to display the Mask menu, and set the pattern
type and modifiers (see page 310).

Blur Settings

Applying the Blur effect
1
In the DME menu, select VF2 'Video Modify' and
HF1 'Defocus/Blur.'
The Defocus/Blur menu appears.
2
Press [Blur], turning it on.
Notes
On the MVE-8000A, the Glow and Blur effects cannot
be enabled at the same time. The effect which was
turned on most recently is enabled.
3
When the DME is connected through an SDI interface,
in the <Blur Mode> group, select the signal to which
you want apply the Blur effect.
Video/Key: Video signal and key signal
Video: Video signal only
Key: Key signal only
4
Set the parameters.
When the DME dedicated interface is used
Knob Parameter Adjustment
1 H Horizontal
defocusing of
video and
key signals
Settings values
0.00 to 100.00
0.00 to 100.00
H value shown
Setting values
0.00 to 100.00