Table of Contents
Advertisement
Shotbox
The term "shotbox" refers to a function whereby for each
specified region any snapshot or keyframe effect can be
recalled simultaneously.
The simultaneous recall setting data such as region names,
snapshot numbers and keyframe effect numbers are stored
in "registers." There are 99 registers for each control panel.
The previous figure shows schematically the settings in the
99 shotbox registers.
Each register may contain any combination of the regions
to which the register applies, with the snapshots or effects
to be recalled.
The Auto Run function is an attribute which can be set for
each register. When this is set to On, an effect recalled by
a shotbox operation is automatically run.
• When register 1 is executed, this recalls M/E-1 snapshot
1, User2 effect 5, and DME ch3 effect 1. For register 1,
auto run is On, and therefore the User2 and DME ch3
effects are run as soon as they have been recalled.
• When register 3 is executed, M/E-1 effect 1, P/P effect
90, and User1 effect 1 are recalled. For register 3, auto
run is off, and therefore to run the recalled effects, press
the [RUN] button in the keyframe control block.
Shotbox Register
Creation
You can create (save) shotbox registers in the following
control blocks.
• Numeric keypad control block (see "Numeric Keypad
Control Block" in Chapter 2 (Volume 1).)
• Menu control block (see "Menu Control Block" in
Chapter 2 (Volume 1).)
• Multifunction Flexi Pad control block (see
"Multifunction Flexi Pad Control Block" in Chapter 2
(Volume 1).)
Creating a Shotbox Register in the
When you create a shotbox register in the numeric keypad
control block, you carry out separate operations in respect
of the snapshot setting data and the effect setting data, and
save in the register. The procedure described here makes
the snapshot settings first, followed by the effect settings.
Creating a shotbox register
1
In the numeric keypad control block, press the
[SNAPSHOT] button, turning it on.
This assigns the numeric keypad control block to
snapshot operations.
2
Specify the register number of the snapshot you want
to save in a shotbox register, and then recall it for each
region.
For details of the procedure for recalling a register,
see "Recalling a snapshot from the numeric keypad
control block" (page 475).
3
Press the [SHOTBOX] button, turning it on.
This assigns the numeric keypad control block to
shotbox operations.
4
Press the [STORE] button, turning it on.
The [SNAPSHOT] button lights green.
If not lighted, press the [SNAPSHOT] button to turn it
on.
Notes
Only in [SHOTBOX] operation mode with the
[STORE] button lit, the [SNAPSHOT] button or
Shotbox / Shotbox Register Creation
489
Advertisement
Table of Contents
