Table of Contents
Advertisement
Copy and Swap
You can copy and swap the settings among the M/E-1 to M/E-3, and PGM/PST
banks or between keyers.
The following settings can be copied or swapped.
• Overall settings for the M/E-1 to M/E-3, and PGM/PST banks
• Keyer settings
• Wipe settings in a transition control block
• Wipe settings in an independent key transition control block
• DME wipe settings in a transition control block
• DME wipe settings in an independent key transition control block
• Matte data (color 1, color 2, and how to compose them)
• Color settings
• DME channel settings
You can carry out copy operations with a simple button operation. Swap
operations, and copy operations on DME data can only be done with a menu
operation.
Note
To carry out DME operations requires the BKDS-9470 DME Board Set or the
MVE-8000A/9000 DME Processor.
For details of the operations, see Chapter 9 "Copy and Swap" (page 479) and
for color correction settings, "Copy and Swap Operations" in Chapter 19
(Volume 2).
M/E copy and M/E swap
You can copy and swap the overall bank settings among the M/E-1 to M/E-3,
and PGM/PST banks.
Target bank
M/E-1
M/E-2
M/E-3
PGM/PST
Note
If a DME is being used on the source M/E bank, then if for example there are
insufficient DME channels, it may not be possible to select the DME.
88
Copy and Swap
Target data
Bank settings excluding the following data items:
• Setup data
• Flexi Pad settings
• Snapshots
• Keyframe effects
• Key snapshots
• Key memory
Advertisement
Table of Contents
