Applying A Dme Effect To A Key - Sony DVS-9000 System User Manual

• When utility 1 bus is selected
Knob
1
2

Applying a DME Effect to a Key

Note
For one M/E bank, DME effects (including DME wipes) can be used in up to
two places on the dedicated interface and in only one place on the SDI interface
simultaneously.
When combining the SDI interface with the dedicated interface, you can apply
DME effects to a maximum of three keys. (Requires a setting in setup.)
Assigning a DME to a key
1
2
You can check the DME operating status in the Status menu (see page 330).
194
Key Setting Operations With the Key Control Block
Parameter Adjustment
Clip Reference level for
creating mask signal
Gain Gain
In the key control block, press the delegation buttons [M/E1] and [KEY1].
Using the DME channel selection buttons, select the DME channel (DME1
to DME4) for applying the effect.
The lit colors of the [DME1] to [DME4] buttons indicate the DME
assignment.
Lit green: Shows the DME assigned to the currently selected key.
Lit amber: Shows the DME assigned to a key other than the currently
selected key.
Off: DME is not assigned.
Note
When assigning two to four DME channels to one key, the selected DME
channels must be successive.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
The later selection is valid, and the button lights green.
Setting values
+109 to –7
–100 (shown as –00) to +100