Sony DVS-9000 System User Manual page 549

Notes
• If you select [Multiply] in the <Fill Blending Mode> group of the Light
Color Adjust menu (see page 551), the light effect is not applied to the
background, even if you select BKGD or Both.
• If the setting of [Brilliancy] in the <Fill Source> group of the Light Color
Adjust menu (see page 551) is 100.00, the light effect is not applied to the
background, even if you select BKGD or Both.
• When the global effect Combiner is set to Mix or Depth, the light effect is
not applied to the background, even if you select BKGD or Both.
To select Surface Flat
Press [Surface Flat], turning it on.
If you have selected anything other than Flat in the <Surface Select> group of
the Spot Lighting menu, the part corresponding only to the surface being struck
by the currently set light from the light source is shown in the same way as if
Flat had been selected.
To set the shape of the light
1
Press [Shape], turning it on.
2
Set the following parameters.
Knob Parameter
1 Shape Ptn
2 Size
3 Deform
4 Soft
5 Angle
a) For more information about the shape patterns, see "Shape Patterns" (page 805) in the
Appendix.
b) 0 is a round shape, and 100 is the shape itself. Smaller values make the pattern more
rounded.
c) –1.00 is one rotation in the counterclockwise direction. +1.00 is one rotation in the
clockwise direction.
To rotate the shape pattern
1
Press [Shape Speed], turning it on.
The display on knob 5 that was visible when [Shape] was selected changes.
2
Set the following parameter.
Adjustment
Shape pattern
Shape size
Amount of shape deformation
Softness of shape pattern
Angle of shape pattern rotation
Setting values
a)
1 to 2
0.00 to 6.00
b)
0.00 to 100.00
0.00 to 100.00
c)
–8.00 to +8.00
DME Special Effect Operations
549