Sony DVS-9000 System User Manual page 972

• When the trigger type is "Level"
Note
"Level Enable" is a function that determines whether GPI inputs are enabled
("Enable") or disabled ("Disable") for the "Aspect" and "Format" actions that
can be used when the trigger type is Level. When Level Enable is used, if the
input is "Disable" then it is not possible to switch "Aspect" or "Format" by GPI
input.
If a GPI to switch "Aspect" or "Format" occurs when powering the system off,
the action triggered by the GPI may start immediately before the power goes
off and the power may go off before the action is completed. This may corrupt
the setup settings. It is therefore recommended to use Level Enable to avoid
such a situation.
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
2
3
972
Interfacing With External Devices (Device Interface Menu)
Recall & Run, User1 to 8 KF Run, User1 to 8 KF Stop, User1 to 8 KF
Rewind, User1 to 8 KF Reverse Run, No Action
When Target is M/E-1, M/E-2, M/E-3, or P/P: Aspect
No Action
When Target is Common/Setup: Format, Aspect, Level Enable, No Action
In the Switcher >Device Interface menu, select the action to be set, and
press [H/L Set].
The H/L Set menu appears.
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment
1 No Selection of setting for action
To apply the selection made in step 2 when the input is high, press [H Set].
To apply the selection made in step 2 when the input is low, press [L Set].
This confirms the setting, which appears in the status area.
Note
When the action is "Format," these settings conflict with the current
settings, but after making the settings, agreement is restored after a pulse
change or power off/on.
Setting values
1 and upwards