Sony DVS-9000 System User Manual page 133

1
Press the [PTN LIMIT] button.
The button you pressed lights green.
2
Carry out the transition.
The [PTN LIMIT] button goes off, and the pattern limit state is released.
Depending on the way in which the transition was executed, the action will
be as follows.
• When you press the [CUT] button, the pattern limit is immediately
released, and the image switches instantaneously.
• When you press the [AUTO TRANS] button, until the state of the next
transition, the transition is carried out over the duration given by the
transition rate.
• When you move the fader lever, the transition is carried out from the
pattern limit state to the state before the pattern limit transition was
carried out.
Moving the fader lever even a little synchronizes the fader lever position
with the transition state, and you can move the fader lever either in the
forward direction or in the reverse direction.
Depending on the Setup settings, the transition may be executed at the
instant you press the [PTN LIMIT] button, and the button goes off. In this
case, execution continues for the time specified by the dedicated transition
rate in the menu setting, as far as the state of the next transition.
For details of the setting, see "Settings Relating to Keys, Wipes, Frame
Memory and Color Correction (Key/Wipe/FM/CCR Menu)" in Chapter 20
(Volume 3).
To set the transition rate when the pattern limit is released
1
In the <Pattern Limit Release> group of the Edge/Direction menu, select
one of the following.
Auto Trans Rate: Use the transition rate set in the transition rate control
block
Independ Trans Rate: Independent transition rate
2
If you selected "Independ Trans Rate" in step 1, adjust the following
parameter.
Knob Parameter
1 Transition Rate
Adjustment
Independent transition rate
Setting values
0 to 999 (frames)
133
Executing a Transition