Sony DVS-9000 System User Manual page 696

4
5
Carry out the following procedures for each of the attributes.
To apply the cross-point hold attributes
Note
Applying the key disable attribute (so the key state is not reflected) to cross-
point hold requires a setting in setup. For details, see "Selecting the Bank to
Make the Settings" in Chapter 20 (Volume 3).
1
2
3
696
Snapshot Operations in the Menus
The selected region name appears in the upper part of the list.
Using any of the following methods, select the register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter
1 Register
2 Num
• To select all registers, press [ALL].
In the <Attribute> group, press the buttons for the attributes you want to
apply, turning them on.
Press [XPT Hold].
The Snapshot>Attribute>Xpt Hold menu appears. The status area shows a
list of the currently selected regions and bus names.
Using any of the following methods, select the register.
• Press directly on the list in the status area. To select one or more buses,
press [Plural] and then select buses.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter
2 a)
Destination
3 b)
Bus
a) Appears when the region is RTR.
b) Appears when the region is other than RTR.
• To select all registers, press [ALL].
When the region is set to RTR (Router) only, press [RTR Level].
Adjustment
Register number
Select number of registers
Adjustment
Destination selection
Bus name selection
Setting values
1 to 99
1 to 99
Setting values
1 to 128
–