Operations Common to All DME Special Effects
In this section, explanations of the operating procedures for individual special
effects begin with selections from the DME menu. The following are common
operations that you must do prior to selecting from the DME menu.
1
In the device control block, select the target DME channel.
2
In the menu control block, select the top menu selection button [DME].
The DME menu appears.
Border Settings
Adding a border
1
In the DME menu, select VF1 'Edge' and HF1 'Border/Crop.'
The Border/Crop menu appears.
2
Press [Border], turning it on.
The Border effect is enabled. You can adjust the border width parameters
with the knobs.
3
Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
Color 2
Color 1
DME Special Effect Operations
449