Sony DVS-9000 System User Manual page 360

Output
connector
OUT19
OUT20
OUT21
OUT22
a) In DSK mode, the backgrounds that can be selected in the PGM Config menu are restricted to
b) Depends on the setting in the Engineering Setup >Switcher >Config >M/E Output Assign menu.
Connectors for which a P/P row output signal can be selected
For an edit preview bus or AUX bus assigned to output connector OUT23 or
OUT24, you can select a P/P row output signal.
If these buses are assigned to other than OUT23 or OUT24, then it is not
possible to select a P/P row output signal. (Assigning these buses to the two
connectors is recommended.)
Output connector
OUT23
OUT24
Logical assignment of the physical PGM/PST
In the Engineering Setup >Switcher >Config >Logical M/E Assign menu, it is
not possible to assign the physical PGM/PST as a logical PGM/PST.
In the <Logical M/E to Physical P/P> group, you can select from M/E-1, M/E-
2, and M/E-3.
Configuration of the switcher bank outputs
If Multi Program mode is selected in setup (M/E Config in the Switcher
>Config menu), then for Bkgd in the PGM Config menu, it is only possible to
select Clean.
360
Simple P/P Software
Fixed assigned outputs
Standard mode
Preview
Clean
Key preview
Preset
background 1 and background 2.
OUT5 and OUT6 cannot be used.
Multi-program mode
b)
P/P OUT2
b)
P/P OUT3
b)
P/P OUT4
Preset
Assignable bus
Edit preview bus
AUX bus
a)
DSK mode
Key preview 1
Key preview 2
Clean 1
Clean 2