Sony DVS-9000 System User Manual page 913

a) Function
Command name
Macro AT with Rate When registering an auto transition
macro event, on/off setting of mode to
save transition rate
Macro AT with A/B Bus When registering an auto transition
macro event for the transition control
block, on/off setting of mode to save A/
B Bus cross-point settings
Macro TL with Region When registering a timeline macro
event, on/off setting of mode to save
applicable region
DME Override DME override on/off
DME Graphic DME graphics on/off (Applies to
graphics for channel selected in device
control block)
System Manager Enbl Enable/disable operation from System
Manager
Plug-In Editor Enbl Enable/disable operation from an
editing keyboard
Inhibit Set Inhibit cross-point button
Inhibit All Clear Clear all cross-point button inhibit
settings
a) For the safe title on/off commands (from ME1 PGM1 ST-ME1 PGM4 ST to AUX1 ST-AUX48
ST), the name of the assigned output signal is shown.
Assigning a menu shortcut to a user preference button
1
Referring to the procedure up to step 2 on page 909, select [Menu
Shortcut].
The user preference buttons [PREFS 1] to [PREFS 16] flash amber.
2
Using any of the following methods, display the menu to which you want
to make a shortcut.
• In the menu control block, press the relevant top menu selection button,
then select VF and HF.
• Press the menu page number button in the upper left corner of the menu
screen, then enter a menu number from the numeric keypad window.
• Press a particular control panel button twice in rapid succession.
3
Press the user preference button to which you want to assign the shortcut.
Button status
Lit amber
On
On
On
On
On
Enabled
Enabled
Can be set only
while pressed (lit)
Can be set only
while pressed (lit)
Setting Button Assignments (Prefs/Utility Menu)
Off
Off
Off
Off
Off
Off
Disabled
Disabled
When the function
is assigned
When the function
is assigned
913