Sony DVS-9000 System User Manual page 129

Frame display mode: Values are shown as from 0 to 999 frames. In this
display mode, a value entered in timecode input mode is converted for
display as a number of frames.
Timecode display mode: Values are shown as timecode values, consisting of
seconds and frames. In this display mode, a value entered in frame input
mode is converted for display as a timecode value. If the value consists of
four or more digits, the last digit is not shown.
Example: A value of 9 seconds 23 frames appears as "9.23" and a value
of 10 seconds 1 frame appears as "10.0."
Setting the transition rate in the numeric keypad control block
SHOT
BOX
TRANS
RATE
AUX
TRANS RATE button
1
In the numeric keypad control block, press the [TRANS RATE] button.
2
Press the region selection button for the M/E or PGM/PST bank for which
you want to set the transition rate, turning it on.
The numeric keypad control block display now shows the selected region
name and the current transition rate setting for the region.
3
With the numeric keypad, enter the transition rate.
• Enter a value of up to three digits.
Display
SNAP
EFF
SHOT
MASTR ALL
MCRO
M/E USER
P/P
1 1
DME DME DME
1 2 3
P-BUS GP1
M/E
P/P
1
AUX AUX AUX AUX
1 2 3 4 5
Region selection buttons
Numeric keypad control block
8
7
UNDO
4 5
STORE
USER
STATS
2
1 2
DME
STORE
4
0
RCALL
AUX AUX FMS FMS
6 7 1 2
Numeric keypad
ENTER button
+/-
9
EFF
DISS
CLR
6 AUTO
TRANS
TRIM
3
GPI
ENBL
ENTER
EDIT
KEY SHIFT
PVW
Executing a Transition
129