Sony DVS-9000 System User Manual page 184

• For one M/E bank, DME effects (including DME wipes) can be used in up
Ending a DME assignment
As an example, to end the assignment of a DME to key 1, in the cross-point
control block, hold down the key row delegation button [KEY1] and press the
DME button ([DME1] to [DME4]) that is lit green.
The button goes off, and this ends the assignment.
Selecting the video signal for a DME assigned to a key
When using the dedicated interface, proceed as follows.
1
2
3
4
When two or more DME channels are assigned, select the video signal for each
DME in the same way.
When using the SDI interface
For keyer channels 3 and 4, select the video signals on the AUX bus assigned
in a Setup menu (Engineering Setup >Switcher >Device Interface >DME
Setting >DME SDI Interface).
In setup (Engineering Setup >Switcher >Device Interface menu), if "Up to
3Keys" is selected, the second channel video signal is also selected on the AUX
bus.
For details, see "Interfacing With External Devices (Device Interface Menu)"
in Chapter 19 (Volume 3).
184
Key Setting Operations With the Cross-Point Control Block
to two places on the dedicated interface and in only one place on the SDI
interface simultaneously.
In the cross-point control block, press the key row delegation button
[KEY1].
The assigned DME button lights amber.
Press the DME button (one of [DME1] to [DME4]) lit amber, which then
lights green.
To select the video signal for the side of the DME image that is currently
visible, make the signal selection in the key row.
To select the video signal for the side of the DME image that is currently
not visible (the back side), hold down the DME button (one of [DME1] to
[DME4]) and make the signal selection in the key row.