Creating A Shotbox Register Using The Menus - Sony DVS-9000 System User Manual

1
2
3
Note
While the [STORE] button is lit, the mode selection buttons ([TRANS RATE]
button and so on) in the numeric keypad control block do not operate. To
change the mode, press the [RCALL] button or [SHOTBOX] button so that the
[STORE] button goes off.

Creating a Shotbox Register Using the Menus

Accessing the Shotbox menu
Carry out creation and editing of shotbox registers in the Shotbox menu.
To access the Shotbox menu, use either of the following methods.
• In the menu control block, press the top menu selection button [SHOTBOX].
• In the numeric keypad control block, press the [SHOTBOX] button twice in
Creating a shotbox register
1
712
Shotbox Register Creation
With the [SHOTBOX] button lit, press the [STORE] button, turning it on.
Press the required button, as follows, turning it on.
To check the snapshot region: [SNAPSHOT] button
To check the effect region: [EFF] button
Hold down the [STORE] button.
While this button is held down, the button for the saved region lights.
Releasing the button returns you to the state before holding down the
[STORE] button.
rapid succession.
In the Shotbox menu, press VF1 'Register' and HF1 'Store/Recall.'
The Store/Recall menu appears.
In the status area, the settings for each register appear as follows.
Region settings: Appear as "Sxxx" when a snapshot is allocated, and as
"Exxx" when an effect is allocated. (xxx is the register number.) The
register name also appears. If nothing is allocated, nothing appears in
the display.
Register lock setting: When the register is write-protected, an "L" (for
"lock") appears.
Empty status: When the register is empty, an "E" (for "empty") appears.
Auto run setting: When this is enabled, so that an effect is executed
simultaneously with recall, "AR" appears.