Executing An Auto Transition - Sony DVS-9000 System User Manual

Executing an Auto Transition

The following two modes can be used for auto transition.
Cut
A cut switches instantaneously from the current video to the new video. When
the next transition is a key transition, the key cuts in or out instantaneously.
Auto transition
The transition from the current video to the new video is carried out
automatically at a constant rate, using the transition effect selected as the
transition type.
You can set the transition rate in advance. (See "Setting the Transition Rate"
(page 128).)
To execute a transition on the M/E or PGM/PST bank by a button operation,
use the following procedure in the transition control block.
To carry out an instantaneous cut transition: Press the [CUT] button.
To carry out a gradual transition: Press the [AUTO TRANS] button.
To complete a partially executed transition instantaneously: Press the
134
Executing a Transition
Fader lever
AUTO TRANS button
CUT button
This executes the transition at the preset transition rate (see page 128).
While the transition is executing, the [AUTO TRANS] button lights
amber. When it completes the button goes off.
[CUT] button.
The [AUTO TRANS] button goes off.
ON ON ON ON
1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4
BKBD KEY1 KEY2 KEY3
KEY SUPER
MIX NAM
PRIOR MIX
PST
ALL COLOR WIPE DME
MIX
PRIOR NORM TRANS
NORM REV
SET /REV
AUTO
TRANS
Transition control block
KEY4
PVW
CUT
PTN LIMIT
KF
LIMIT SET