Sony DVS-9000 System User Manual page 416

The following table shows the interval between successive detents for each
transformation operation mode (see page 417).
Operation mode
Location XYZ
Rotation, Spin
Axis Location
Location Size
Aspect
Perspective (x, y)
Perspective (z)
Skew
a) When a value is smaller than 1, 1/Aspect or 1/Perspective (z) is adjusted to an integral value.
Three-dimensional parameter default values
Each of the transformation operation modes has default values for three-
dimensional parameters. If required, you can return the current value to the
defaults by pressing the [CTR] (page 426) button in the device control block
twice in rapid succession.
The following table shows the default parameter values for each
transformation operation mode.
Operation mode
Location XYZ
Rotation, Spin
Axis Location
Location Size
Aspect
Perspective (x, y)
Perspective (z)
Skew
Resetting of parameter values set in the source coordinate space
In some transformation operation modes, if you switch to the target coordinate
space after setting up a three-dimensional transformation in the source
coordinate space, the setting values in the source coordinate space (three-
dimensional parameter values) are converted to values in the target coordinate
space (source/target conversion).
Once a conversion has taken place, the original source coordinate space
parameters do not return to their original values when you switch back to the
source coordinate space. They are reset to zeros.
416
DME
Detent interval
1.0000
0.2500
1.0000
0.2500
a)
1.0000
1.0000
a)
1.0000
0.1000
Default value
0.0000
0.0000
0.0000
1.0000
1.0000
0.0000
1.0000
0.0000