Sony DVS-9000 System User Manual page 170

4
170
Key Setting Operations Using Menus
When drop border or shadow is selected: The setting parameter values
depend on the on/off setting of key drop and the selection of 4H mode/
8H mode (see page 151).
• "Key drop OFF" mode
Knob Parameter Adjustment
1 Width Width
2 Position Position
3 Density Density
• "Key drop ON" mode
Knob Parameter Adjustment
1 Width Width
2 Position Position
3 Density Density
a) In the "4H mode" and when [Fine Key] (page 171) is on, the setting value range is 0.00
to 4.00.
When emboss is selected:
Knob Parameter Adjustment
1 Width Width
2 Position Position
3 Density
a)
Density
a) The Density adjustment only affects the key edge. This can be adjusted separately from
Key Density, and if Key Density is set to 0.00, the embossed edge effect only can be
applied.
To make edge fill adjustments, carry out the settings in step 6.
Select the edge fill signal in the <Edge Fill> group.
Utility 1 Bus: signal selected on the utility 1 bus
Matte: signal from dedicated color matte generator.
It becomes possible to adjust color 1.
Knob Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
Setting values
0.00 to 8.00
359.99 to 180.00
0.00 to 100.00
Setting values
a)
0.00 to 8.00
359.99 to 0.00
0.00 to 100.00
Setting values
0.00 to 4.00
359.99 to 0.00
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00