Sony DVS-9000 System User Manual page 546

To set a test sphere
1
2
Setting light sources
Up to three light sources (Light 1 to Light 3) for Spotlighting can be set by
menus.
Light source menu
The following three light source menus are available.
Light source
Light 1
Light 2
Light 3
Note
The BZS-9471 Texture Lighting Software (for BKDS-9470) or BZDM-9050
Texture Lighting Software (for MVE-9000) is required to enable Light 2 and
Light 3.
An install key must be entered to use the software. (For details, see
"Installation and Device Setup (Install/Unit Config Menu)" in Chapter 18
(Volume 3).)
To set light source data
The following example shows how to set light source data with the Light 1
menu.
If you use multiple light sources, use the same procedure for all light sources.
1
546
DME Special Effect Operations
In the Spot Lighting menu, press [Test Sphere], turning it on.
A test sphere effect appears on the image surface.
Adjust the following parameter.
Knob Parameter Adjustment
5 Amp Distance of light
a) Light appears from Z direction. At –100.00 the light goes deepest, at +100.00 the whole
image is lit like a flat effect.
For details of the relationship of test spheres and light sources, see
"Relation between test spheres and parallel rays" (page 541).
In the <Spot Lighting Adjust> group of the Spot Lighting menu, press
[Light 1].
The Light 1 menu appears.
Menu
DME >Light/Trail >Spot Lighting >Light 1
DME >Light/Trail >Spot Lighting >Light 2
DME >Light/Trail >Spot Lighting >Light 3
Setting values
a)
–100.00 to +100.00