Sony DVS-9000 System User Manual page 241

Hide thumbs Also See for DVS-9000 System:

Table of Contents

At the first transition completion point, if you move the image with the

positioner, the transition appears as in the following figure.

Signals forming part of the background for a DME wipe

For a two-channel mode page turn, page roll, brick, frame in-out, and so on, the

part of the pattern shown in gray (see page 377) is filled with the signal selected

on the DME external video bus.

For three-channel mode brick, the part of the pattern shown in dark gray is

filled with the DME external video signal, and the light gray portion with the

signal selected as follows.

For a DME dedicated interface

The signal selected on the utility 1 bus.

For an MVE-8000A or MVE-9000 SDI interface

Signal selected on the AUX bus assigned in the Engineering Setup >Switcher

>Device Interface >DME Type Setting >DME SDI interface menu. (The AUX

bus is determined by which DME channel is being used.)

For the SDI interface on the MVE-8000A or MVE-9000, in some cases the

AUX bus is used in place of the DME external bus.

First transition

Transition start

completion point

Effect execution

Transition end

Image created

by interpolation

Background A

Background B

State before

modification

Dvs-9000sf system