Alcatel-Lucent 1665 Installation Manual page 157

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6
Install the PTM module per
........................................................................................................................................................................................................................
7
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW67 (1G SX) installation (optional)
Follow this procedure only if installing LNW67 (1G SX) circuit packs into the Alcatel-
Lucent 1665 DMX shelf.
Note:
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group slot (A1, A2,
B1, B2, C1, C2, D1, D2) and/or growth slot (G1 or G2) where the LNW67 circuit pack
will be installed.
Note:
pack can only be installed in slot 1 of any function group or growth slot 1.
........................................................................................................................................................................................................................
2
Remove the LNW67 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf function group slot as required. Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Install a blank circuit pack into the companion fn circuit pack slot as required.
Important!
for cooling.
........................................................................................................................................................................................................................
5
Repeat
equipped with LNW67 circuit packs.
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
Install pluggable transmission modules (PTM) (p.
S
F T E P S
The LNW67 (1G SX) requires multi-mode fiber.
Unless equipped with LNW59 or LNW82 VLF mains, the LNW67 circuit
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 4
Appendix E, "Installation
for each additional function group and/or growth slot to be
Initial circuit pack installation
2-33).
checklist".
2 - 2 9