Alcatel-Lucent 1665 Installation Manual page 156

Data multiplexer (dmx)
Hide thumbs Also See for 1665:
Table of Contents

Advertisement

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
LNW70 (100/1G FXS), LNW74 (10/100 T/F), LNW63 (1000BASE-SX/LX/LX10), LNW64 (8 GbE),
LNW78 (RPR) and LNW170 (100/1G FXS) installation (optional)
Follow this procedure only if installing LNW70 (100/1G FS), LNW74 (10/100 T/F),
LNW63 (1000BASE-SX/LX/LX10), LNW64 (8 GbE), LNW78 (RPR) and LNW170
(100/1G FXS) circuit packs into the Alcatel-Lucent 1665 DMX shelf.
Note:
require PTM modules for the Ethernet interface. This procedure will consist of two
parts. Installing the circuit card and installing the PTM per
transmission modules (PTM) (p.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group slot (A1, A2,
B1, B2, C1, C2, D1, D2, G1 or G2) where the LNW70, LNW74, LNW63, LNW64,
LNW78 or LNW170 circuit pack will be installed.
Note:
100 Base-F ports are available for use.
The LNW70, LNW74, LNW63, LNW64, LNW78 and LNW170 circuit packs can
only be installed in slot 1 of any function group unless the mains are equipped with
LNW59 or LNW82 (VLF) main circuit packs. With the LNW59 and LNW82 mains,
both slots in a function group may be equipped.
........................................................................................................................................................................................................................
2
Remove the LNW70, LNW74, LNW63, LNW64, LNW78 or LNW170 from the packing
material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf fn slot. Do NOT engage the circuit pack in the
backplane connector.
........................................................................................................................................................................................................................
4
Install a blank circuit pack into the companion function group circuit pack slot as required.
Important!
for cooling.
........................................................................................................................................................................................................................
5
Repeat
LNW70, LNW74, LNW63, LNW64, LNW78 or LNW170 circuit packs.
............................................................................................................................................................................................................................................................
2 - 2 8
The LNW70, LNW74, LNW63, LNW64, LNW78 and LNW170 circuit packs
When LNW74 is installed in the G1 or G2 position, only the faceplate optical
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1
through
Step 4
2-33).
for each additional function group to be equipped with
Initial circuit pack installation
Install pluggable
365-372-304R7.1
Issue 2 March 2008

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents