Alcatel-Lucent 1665 Installation Manual page 227

Installation tests
............................................................................................................................................................................................................................................................
Result:
LEDs should be lit on the SYSCTL circuit pack.
The alarm on the SFP module will flash.
........................................................................................................................................................................................................................
5
From the system view click Alarm List to verify that the circuit pack alarm is associated
with the optical port being tested.
........................................................................................................................................................................................................................
6
Select Configuration -> Update System... -> Update All.
Requirement: The flashing FAULT LED should extinguish on the OLIU. There
should be no alarm indications on the Alcatel-Lucent 1665 DMX shelf.
........................................................................................................................................................................................................................
7
From the system view click Alarm List to verify that the circuit pack alarm is cleared.
........................................................................................................................................................................................................................
8
Repeat this entire procedure for each LNW37, LNW45, LNW49, LNW55 or LNW62 SFP
equipped in the Alcatel-Lucent 1665 DMX shelf.
........................................................................................................................................................................................................................
9
Replace all protective dust covers on the LNW37, LNW45, LNW49 or LNW62 SFP
OLIU connectors (OLIU and LGX), that were removed to perform this procedure.
........................................................................................................................................................................................................................
10
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
The FAULT LED should begin flashing on the OLIU and only the MN and NE
S
F T E P S
OC-3 (LNW37, LNW45, LNW55)/OC-12 (LNW49,
LNW55)/OC-48 (LNW55, LNW62) low-speed SFP test
Appendix E, "Installation checklist".
4 - 4 3