Alcatel-Lucent 1665 Installation Manual page 222

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
9
Connect the RJ45 cable to the next jack on the RJ45 patch panel and repeat starting at
5 until all connected jacks have been tested.
........................................................................................................................................................................................................................
10
Check off the appropriate box in
E O
N D
........................................................................................................................................................
Ethernet port wiring verification testing
Note:
complete for LNW71 and LNW74 packs!
........................................................................................................................................................................................................................
1
If not still connected serially from the last procedure then, connect the Front CIT cable
between the PC and the CIT/RS-232 jack of System Controller and login to the shelf using
the serial connection.
........................................................................................................................................................................................................................
2
Select Configuration -> Data -> Create Virtual Switch.
........................................................................................................................................................................................................................
3
Choose the LNW66 that is being tested.
........................................................................................................................................................................................................................
4
Click Select.
........................................................................................................................................................................................................................
5
Enter Virtual Switch ID: 1.
........................................................................................................................................................................................................................
6
Under Ethernet (LAN) Ports, click Select All.
........................................................................................................................................................................................................................
7
Click Apply.
........................................................................................................................................................................................................................
8
Click Close.
........................................................................................................................................................................................................................
9
Select Configuration -> Data -> Create VLAN.
............................................................................................................................................................................................................................................................
4 - 3 8
S
F T E P S
Continue with the following section only for LNW66 circuit packs. Testing is
LNW66, LNW71 and LNW74 (10/100T) TX ethernet cabling
Appendix E, "Installation checklist".
365-372-304R7.1
Issue 2 March 2008
testing
Step