Alcatel-Lucent 1665 Installation Manual page 23

Physical installation and powering
............................................................................................................................................................................................................................................................
Quantity
1
1
1
1
1
1
1
1
1
1
1
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
Description
*
Thomas & Betts R-
5648B Crimping Tool
†
Paladin Coaxial Wire
Stripper R-5648B
†
Replacement Paladin
Cassette R-5648B D5
Wire-Wrap Gun
R-4496A
Impact Tool -Wire
R-5974
ESD Wrist Strap
R-4987C
Torque Wrench
R-5952
Multimeter (Optional)
ITE-6379C
Ohmmeter
ITE-6379C
DS1 Error Rate Test Set
ITE-7113
DS3 Error Rate Test Set
ITE-7113
SONET Optical Test Set
Comments
The crimping tool and wire stripper are only
required if installing DS3 cables. The replacement
cassette is for the wire stripper tool.
The wire-wrap gun is required for terminating
DS1 cable and must be able to accommodate 24
gauge wire.
The impact tool is required for terminating
Ethernet cable onto a 110 type panel.
A wrist strap must be worn when handling circuit
packs. Use the electrostatic discharge (ESD) jack
provided on the shelf.
A torque wrench (50-250 IN-LBS) is used when
1665 DMX
tightening the
also used when reattaching the mounting brackets
to the 1665 DMX shelf.
The voltmeter must be capable of measuring DC
voltage in the 40 to 60 volt range. The use of the
voltmeter is optional since the shelf will alarm or
shut down if the proper voltage is not supplied.
An ohmmeter is required to verify that the
DMX
is properly grounded.
A DS1 error rate test set is required for testing of
DS1 cabling. A T-BERD 2209 or equivalent is
recommended.
A DS3 error rate test set is required for testing of
DS3 cabling. A T-BERD 209 or equivalent is
recommended.
An OC-3, OC-12 or OC-48 test set as required for
testing of optical circuit packs. An Agilent
OmniBER 718 or equivalent is recommended.
shelf to the frame. It is
1665
I- 3