Alcatel-Lucent 1665 Installation Manual page 152

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group(s) and/or
growth slot(s) where the low-speed OLIU circuit packs will be installed.
........................................................................................................................................................................................................................
2
Remove the OLIU from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, B1, C1, D1 or G1 as required). Do NOT
engage the circuit pack in the backplane connector.
Note:
slots A2, B2, C2, D2, G2. Always consult the engineering job specification for
placement of circuit packs.
........................................................................................................................................................................................................................
4
If a companion circuit pack is required, continue with
pack into the companion circuit pack slot (A2, B2, C2, D2 or G2 as required), then
proceed to
Note:
for cooling.
........................................................................................................................................................................................................................
5
Remove the second OLIU from the packing material.
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot A2, B2, C2, D2 or G2 as required). Do NOT
engage the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
7
Repeat
equipped with LNW37, LNW45, LNW49, LNW55 or LNW62 circuit packs.
........................................................................................................................................................................................................................
8
Install the PTM module per
........................................................................................................................................................................................................................
9
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
2 - 2 4
If using LNW59 or LNW82 (VLF) mains, the circuit pack may be installed in
Step 7.
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 6
Install pluggable transmission modules (PTM) (p.
S
F T E P S
for each additional function group and/or growth slot to be
Appendix E, "Installation
Initial circuit pack installation
Step 5. If not, install a blank circuit
checklist".
Issue 2 March 2008
2-33).
365-372-304R7.1