Alcatel-Lucent 1665 Installation Manual page 153

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
LNW46 (OC-12 OLIU) low-speed installation (optional)
Follow this procedure only if installing LNW46 (OC-12 OLIU) circuit packs into the
Alcatel-Lucent 1665 DMX High-Capacity shelf.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group(s) and/or
growth slot(s) where LNW46 circuit packs will be installed.
........................................................................................................................................................................................................................
2
Remove the LNW46 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, B1, C1, D1 or G1 as required). Do NOT
engage the circuit pack in the backplane connector.
Note:
slots A2, B2, C2, D2, G2. Always consult the engineering job specification for
placement of circuit packs.
........................................................................................................................................................................................................................
4
If a companion circuit pack is required, continue with
pack into the companion circuit pack slot (A2, B2, C2, D2 or G2 as required), then
proceed to
Important!
for cooling.
........................................................................................................................................................................................................................
5
Remove the second LNW46 from the packing material.
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot A2, B2, C2, D2 or G2 as required).
........................................................................................................................................................................................................................
7
Repeat
equipped with LNW46 circuit packs.
........................................................................................................................................................................................................................
8
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
If using LNW59 or LNW82 (VLF) mains, the circuit pack may be installed in
Step 7.
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 6
S
F T E P S
for each additional function group and/or growth slot to be
Appendix E, "Installation
Initial circuit pack installation
Step 5. If not, install a blank circuit
checklist".
2 - 2 5